Knife Maker's Center Line Scribe, Block Scribe, 2 X 72 Knife Grinder Scribe For Sale

This is a New Knife Maker's Center Line BlockScribe. These are used the same way you would use a height gauge. The body is made from 6061 Grade Aluminum bar stock. The dimensions are 1" X 1" X 2" long. There is a V shaped groove milled into the body to accept the 1/8" caroffere rod. The thumb screw is solid brass and is threaded 1/4"-20. The tungsten caroffere rod has a beautifully ground point on one end and a slight chamfer on the back end. The aluminum body has a 1/4"-20 threaded thru hole in it to accept the thumb screw. A new style heavy machined aluminum washer under the thumb screw secures the caroffere rod in the block's V-groove. This scribe will adjust from Zero to a little over 1/4" high so you can use it to mark the center of a piece of stock up to at least 1/2" thick. These are simple and easy to use to make a single or the dual lines which many prefer. Either way always mark your stock from both sides of your work. Made in The USA in a Small New Hampshire Shop.Please note:This sale is for the aluminum block, tungsten rod, washer and brass thumb screw as seen in the last photo.The knife blank, ruler, and steel stock is NOT included.