When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
This is a NEW replacement Power Supply boardfromGulf Pinballused in early Bally and Stern pinball machines. The original part numbers were Bally AS-2518-18, AS-2518-49 and Stern TA-100.
This board requires no soldering like the original. Instead screw terminals are used to simplify the change. Cut the old wires from the original board, strip and connect to the new board. A small flat screwdriver is needed. Complete Instructions included. There is also a YouTube video on installation tips.
If you prefer the SOLDER install version, see listing225596630012
Improvements over the original are :
- 20amp 600volt capacity bridges on BR1, BR2 and BR3 with heat sinks on all 3.
- Extra pin on connector J1 (pin 9) to support -49 games (Future Spa, KISS, Space Invaders)
- All connectors are Molex brand
- Fuses and fuse clips are Buss/Cooper Bussman
- Test Points at top to measure output voltages
- New plastic push-on mounting clips included
Payment by Paypal only. Shipping by USPS Ground Advantage FREE within the USA. International shipments through the Global Shipping Program only.
