|
Site Categories |
|
Featured Items |
Poodle, Spaghetti Trim, Ucagco
|
Vintage L.S. Starrett No. 457C Improved Diemakers’ Square & Offset Blade For Sale
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Vintage L.S. Starrett No. 457C Improved Diemakers’ Square & Offset Blade : $189.95
This is a Used Very Good to Excellent ConditionVintage L.S. StarrettImproved Diemakers’ Square and Beveled Offset Blade!Model Number457C! This model is still available New from Starrett for $298.00!Works Great no rust or nicks! There are two \"S\" electro etched on it! Very Lightly done! On one of the sides there is a Very Small spot where there was surfacecorrosion! It is cleaned and will not hurt the function! Also there is surface wear on the angle grid from the needle moving up and down!See the picturesso you can judge the condition for yourself! Remember what you see is what your going to get! All sales are final! Shipping is included on this item! Thanks for looking Mike!For the factory specifications and usage please see below! This data is from Starrett not me!The Starrett 457 Improved Diemakers’ Square is a highly useful tool for tool and diemakers, especially for measuring die clearances. It is also very handy for pattern makers to check angles and drafts on patterns. The beam of this square is graduated to show the setting in degrees of the blades. Blades can be set for any angle up to 10°, either side of 0º and the angle is indicated by the line on the pointer. Complete, with Straight and Offset Blades. - The beam is beveled adjacent to the blade so that the blade is readily visible when checking in holes, slots, etc.
- Blades and beams are hardened and ground
- Graduated blade, 32nds of an inch on one side, and 64ths on other. It is 5/32\"wide over a length of 1-5/8\" and cut away at one end to a width of 3/32\"
- The offset blade is 1/8\" (3mm) wide and both sides of each edge are beveled to give visual line contact
- Type:Improved Diemakers’ Square with angular adjustment
- Blade Length (in):1-5/8\"
- Graduations:32nds - 64ths
- Material:Steel
|
|
Related Items:
L. S. Starrett Co. Athol , Mass 12FT/144in Steel Tape Measure vintage no. 504 $15.00
Vintage 1940s Serape Saltillo Wool Blanket Rug 82" X 45" Southwest Mexican EUC $125.00
Vintage L.S. Starrett Athol 923 Bench Vise w/ Swivel Base - EXCELLENT ORIGINAL $679.99
|
|
|
Shopping Cart |
|
Recently Viewed |
|
Latest Items |
|
Facebook |
Secure Websites
|