When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Charlie Wheel Slicing Edge Sharpening SystemsNewWheels will fit a buffer or grinder with a 1/2 inch shaft
(May have to remove guards if the buffer/grinder has them)
Should run at least 3000 rpm but less than 3600 rpmsWheels are about 7 7/8 inch in diameter and 3/4 inch wideIncluded in the package is a container of goose grease to use on the gritted wheela container of white buffing compound to use on the buffing wheela small package of silicon caroffere included if you need to recondition the wheelsan instruction sheet that tells how to install the wheelshow to use them, and how to recondition when needed.also a toll free number to call if there is any need for assistancefrom the manufacture.
Package also contains reconditioning instructions
A quick reference instruction set is also included in the packageAn 800 phone number is available for technical assistance
Check out the sellers other Forschner/Victorinox products
